Login   |   Register
Welcome to KernelClankers — a friendly community for Linux users and 3D printing enthusiasts.
Whether you're a beginner or veteran, feel free to introduce yourself and share your projects!
KernelClankers › Projects & Builds › Show Your Prints
My first successful print on Linux – Raspberry Pi case

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
My first successful print on Linux – Raspberry Pi case
WL7JA Offline
Super Moderator
******
Posts: 8
Threads: 8
Joined: 3 April 2026
Reputation: 0
#1
Yesterday, 22:20
Here's my first decent print done entirely on Linux using Orca Slicer.

It's a simple but sturdy case for my Raspberry Pi 5. Printed in PLA, 0.2mm layer height, no supports needed.

What do you think? Any suggestions for improvements?

[Attach a photo of the print here]
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)